Brother printer manual feed load paper error

This issue can occur for various reasons: The paper source in the application is set to "Manual feed" or "MP tray". - The paper size is set to a custom or special size. - The document was created using a wizard (i.e. Envelopes or Labels in Microsoft Word). The document will print according to the rules set up in the wizard instead of the driver. - Click Start = (Settings) = Control Panel = Printers (and Faxes) or - Click Start = Control Panel = Printers and Other Hardware = View Installed Printers. Windows Start = Settings = Printers. b. On the Basic tab, verify the Paper Source at the bottom of the window is set for the correct paper tray. c. Click Apply if you make a change. Lift and unfold the ADF document support (1). Fan the stack of paper well to avoid paper jams and misfeeds. Adjust the paper guides (1) to fit the document size. Place your document, face down, top edge first in the ADF underneath the paper guides until you feel the document touch the feed rollers and the LCD displays [ADF Ready].

the brother printer will not print from the computer. The screen reads: Manual Feed Load paper." There is plenty of paper. It printed earlier today. I have tried unplugging the printer but it went bac read more. 2. Remove any paper that is jammed in and around the manual feed slot. 3. Press the GO key to resume printing. The display will show Manual Feed with a scrolling message to load the paper size you are printing on. 4. Use both hands to push one sheet of paper firmly into the manual feed slot until the top edge of the paper presses again the. Brother DCP says Manual Feed Insert Paper. My Brother DCP Printer Scanner prints a few pages ok. My Brother DCP Printer Scanner prints a few pages ok then paper crumples and jams in the back. I've tried everything that's been read more.

7. Insert paper into the Manual Feed Tray and allow the print job to complete. If the error message is still on the Brother machine, cycle the power to clear the message. Once the message is clear, continue to the next step. NOTE: The instructions below are for Microsoft Word. If you are using a program other than Microsoft Word or a different version, search for the Default Paper Source and Default Paper Size settings. Pull out the paper support (1) until it locks into place, and then unfold the paper support flap (2). If the document does not fit on one sheet, the machine will prompt you to load another sheet of paper. Place another sheet of paper in the manual feed slot, and follow the instructions displayed on the LCD. DO NOT load paper in the manual feed slot when you are printing from the paper tray. Doing this may cause a paper jam. Using both hands, push one sheet of paper into the manual feed slot until the front edge touches the paper feed rollers. Release the paper when you feel the machine pull it.